Super Intensifier

Universeal Super Intensifier

Colour intensifier and restorer for Victorian tiles and porous natural stone

Usage Guidelines

---

Coverage:	Up to a maximum of 30m2 per litre per coat Coverage offered as guidance. Will vary depending on surface porosity, texture and application process.
Drying Time:	1 hour between coats, fully cured 48-72 hours
Applications/Coats:	2 Coats
Application Method:	Sponge / Sprayer / Brush / Paint Pad
Dilution:	Undiluted

Documentation

---

Technical Application Guide

Max Colour Enhancer for natural stone and porous tile

Universeal Super Intensifier’s new colour enhancer technology is designed to massively deepen stone’s hue and colour. This natural stone colour intensifier is perfect for restoring old and faded Victorian tiles.

Super Intensifier outdoor stone colour restorer is a high-performance solvent-based max colour enhancer that penetrates into the surface of the stone to protect from staining whilst giving a bold, deeply colourful look. The high polymer formula is ideal for the restoration of Victorian Tiles and geometric tiles and is also suitable for all porous stone and tile surfaces. NOT RECOMMENDED FOR USE ON NON-POROUS, GLAZED SURFACES.

Special Features

• Boosts natural colours and restores faded colours for a deep, vibrant look
• For use on natural porous stone surfaces including commonly installed sandstone, slate, and limestone; also suitable for all porous tile surfaces
• Can be applied internally & externally
• Protective coating helps to prevent stains and retain colour
• 100% breathable, polymer-rich impregnating solvent formula

DIRECTIONS FOR USE:

1. Read these instructions fully. Always perform a test in an inconspicuous area on-site to check the suitability of the product, prior to use. ALWAYS WEAR APPROPRIATE PPE DURING APPLICATION.
2. Before application, the surface must be completely clean and dry.
3. Apply an even coat with a low-pressure sprayer, paint pad, natural fibre brush or sponge. The sealer will sink (impregnate) into the stone; any excess sealer must be completely removed from the surface within 15 minutes by buffing off with a lint-free cloth.
4. After at least 1 hour, apply a second thin and even coat, again taking care to buff off any excess sealer with a cloth within 15 minutes. The finished result will be a matt, non-shine finish with deep, vibrant colouration (mid to dark tones will show the most dramatic results).
5. After application, the stone surface must be kept dry through the curing process (up to 72 hrs). Any moisture or water left on the surface within this time may result in the sealer drying inconsistently, leading to hard-to-remove white patches.

Please Note:

Application range: 5°c – 20°c. Areas not to be sealed with Super Intensifer outdoor stone colour restorer must be protected with masking materials.

Expected Wear

Under typical conditions, the effect of the impregnation can be considered to have an effect for up to 5 years. Effectiveness and longevity are reliant on initial thorough application, foot traffic and the use of correct maintenance cleaning products.

Coverage:

Up to a maximum of 30m2 per litre per coat.
Coverage is offered as guidance. Will vary depending on surface porosity, texture and application process.